|Re: 2400 takeapart advice/experience [message #277006 is a reply to message #276979]
||Wed, 31 December 2014 16:12
Registered: December 2014
Short progress report.|
As you know there is no HD in place but that's ok, I can create a bootable
floppy with a minimal system on a powerbook G3 or even my other 2400
Some interesting things:
1) Attached keyboard
2) When attaching display cables, 2 of which socket right to the MLB, a
third has a hole and I believe it is ground. I had to fasten it down with
tape until I can source a screw for it.
4) SDRAM back in the slot.
3) I held down the reset key when powering up and got a steady green light
at the top.
I will continue trying resets
Note: PRAM battery remains disconnected.
Any advice would be appreciated. Thanks!
Was completely dead whereas now I have a steady green light (is this GLOD?)
You received this message because you are a member of the PowerBooks list, a group for those using pre-G3 PowerBooks.
The list FAQ is at http://lowendmac.com/lists/powerbooks.shtml and our netiquette guide is at http://www.lowendmac.com/lists/netiquette.shtml
To post to this group, send email to firstname.lastname@example.org
To leave this group, send email to email@example.com
For more options, visit this group at http://groups.google.com/group/powerbooks
You received this message because you are subscribed to the Google Groups "PowerBooks" group.
To unsubscribe from this group and stop receiving emails from it, send an email to firstname.lastname@example.org.
For more options, visit https://groups.google.com/d/optout.