Re: 2400 takeapart advice/experience [message #277006 is a reply to message #276979] |
Wed, 31 December 2014 16:12 |
Alex Santos
Messages: 58 Registered: December 2014
Karma:
|
Member |
|
|
Short progress report.
As you know there is no HD in place but that's ok, I can create a bootable
floppy with a minimal system on a powerbook G3 or even my other 2400
Some interesting things:
1) Attached keyboard
2) When attaching display cables, 2 of which socket right to the MLB, a
third has a hole and I believe it is ground. I had to fasten it down with
tape until I can source a screw for it.
4) SDRAM back in the slot.
3) I held down the reset key when powering up and got a steady green light
at the top.
TO DO:
I will continue trying resets
Note: PRAM battery remains disconnected.
Any advice would be appreciated. Thanks!
Was completely dead whereas now I have a steady green light (is this GLOD?)
Alex
--
--
-----
You received this message because you are a member of the PowerBooks list, a group for those using pre-G3 PowerBooks.
The list FAQ is at http://lowendmac.com/lists/powerbooks.shtml and our netiquette guide is at http://www.lowendmac.com/lists/netiquette.shtml
To post to this group, send email to powerbooks@googlegroups.com
To leave this group, send email to powerbooks+unsubscribe@googlegroups.com
For more options, visit this group at http://groups.google.com/group/powerbooks
---
You received this message because you are subscribed to the Google Groups "PowerBooks" group.
To unsubscribe from this group and stop receiving emails from it, send an email to powerbooks+unsubscribe@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.
|
|
|