Re: 2400 takeapart advice/experience [message #276968 is a reply to message #276941] |
Wed, 31 December 2014 12:55 |
Alex Santos
Messages: 58 Registered: December 2014
Karma:
|
Member |
|
|
Re point 6
Ok, this is the reset switch and I found out where it gets connected to on
the logic board.
> 6) One cable was found detached but I believe I know where it goes, it's
> the single cable coming from part 9222-2990 (structure assembly - see
> Apple's service source exploded view), oddly I do not know what it does
> because the cable attaches to the MLB but I don't know what purpose it
> serves since the cable leads to a small component on the said part but the
> part is simply screwed on to the assembly. Does anyone know what it does? I
> believe it attaches to J1 on the MLB
>
--
--
-----
You received this message because you are a member of the PowerBooks list, a group for those using pre-G3 PowerBooks.
The list FAQ is at http://lowendmac.com/lists/powerbooks.shtml and our netiquette guide is at http://www.lowendmac.com/lists/netiquette.shtml
To post to this group, send email to powerbooks@googlegroups.com
To leave this group, send email to powerbooks+unsubscribe@googlegroups.com
For more options, visit this group at http://groups.google.com/group/powerbooks
---
You received this message because you are subscribed to the Google Groups "PowerBooks" group.
To unsubscribe from this group and stop receiving emails from it, send an email to powerbooks+unsubscribe@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.
|
|
|