|2400 takeapart advice/experience [message #276880]
||Tue, 30 December 2014 14:24
Registered: December 2014
I think this is the right place to post.
I have a 2400c that I purchased about 7 years ago. I knew it was dead at
the time but I bought it anyway, for obvious reasons.
I have been told that it might be the PRAM that is keeping it from lighting
up. I have another 2400c that works so I know I have a working PSU.
I also understand that I have to take the machine entirely apart to remove
the PRAM battery as a test.
Does anyone know a good link showing a 2400 takeapart? I have been
searching around but nothing worthy comes up.
Also, If you have taken one apart is it a very complex takeapart? I have
done eMacs and iMac G3s and powerbook pismos to install RAM and hard
drives. In the case of the eMac it was a complete takeapart aside from the
Any advice or links would be greatly apprecaited.
I might want to change the HD on this fellow, any recommendations?
Thanks in advance.
You received this message because you are a member of the PowerBooks list, a group for those using pre-G3 PowerBooks.
The list FAQ is at http://lowendmac.com/lists/powerbooks.shtml and our netiquette guide is at http://www.lowendmac.com/lists/netiquette.shtml
To post to this group, send email to firstname.lastname@example.org
To leave this group, send email to email@example.com
For more options, visit this group at http://groups.google.com/group/powerbooks
You received this message because you are subscribed to the Google Groups "PowerBooks" group.
To unsubscribe from this group and stop receiving emails from it, send an email to firstname.lastname@example.org.
For more options, visit https://groups.google.com/d/optout.