Pentium 4 motherboard showing signs of capacitor problems.
Anybody who collects or uses old computers knows there are a variety of problems you can come across. Heck, even modern computers have some of these issues. Over the years, I think the most common problems I have run across are power supply related. Bad hard drives are pretty common too but those are the easiest to figure out. Bad memory can be a problem but personally, I don’t think I have ever run across a problem that was caused by bad memory though there always seems to be a lot of emphasis on that possibility. Then there are the harder problems to figure out…
Sometimes a computer will become unstable and spontaneously reboot or freeze periodically. A bad power supply can cause this sort of thing but that’s not always the case and from there the problem can get harder to diagnose.
A number of years ago due to safety concerns and changes in the law, most solder changed to a lead free formula. Early implementations (and I’m still not sure the problem has been completely resolved) could crack due to heat stresses. Older Core 2 Duo Dell laptops that had nVidia graphics chips had this problem in part because those chips ran so hot. One symptom was that the laptop turned on but never booted. Often, turning it off and back on a few times (or even putting pressure at the right spot) would seem to fix the problem. It can also cause random reboots. These problems usually get worse over time and the only fixes are to reflow the solder (usually a temporary fix) or replacement of the motherboard. This problem also affected at least some PlayStation 3 and Xbox 360 models.
Another fairly common problem on computers of a certain vintage is bad capacitors. If you open up your computer and you see bulging or leakin