Home »
Digital Archaeology »
Computer Arcana »
Commodore »
Commodore Emulation »
BRK-flag
BRK-flag [message #137501] |
Tue, 05 April 2005 06:07 |
Ruud.Baltissen
Messages: 64 Registered: July 2003
Karma:
|
Member |
|
|
Hallo allemaal,
Experimenting with VICE I noticed something strange. In the monitor
mode the BRK-flag was 0. But stepping through the instructions PHP and
PLA A was $32 at the end, meaning the BRK-flag was set at the moment
of PHP. But the monitor command 'r' showed the BRK-flag was 0.
I realise that stepping is done by using the BRK instruction and that
this is the possible cause of the set BRK-flag. But then why doesn't
it show with 'r'?
But the reasob I started experimenting: the BRK-flag is set by the BRK
instruction. But what does it reset again? I couldn't find anthing
about it and the only thing I can think of is an IRQ.
Any comment is welcome!
--
___
/ __|__
/ / |_/ Groetjes, Ruud
\ \__|_\
\___| URL: Ruud.C64.org
|
|
|
Goto Forum:
Current Time: Thu May 09 22:53:40 EDT 2024
Total time taken to generate the page: 0.03791 seconds