Message-ID: <143@osu-eddie.UUCP>
Date: Sat, 2-Mar-85 14:55:40 EST
Article-I.D.: osu-eddi.143
Posted: Sat Mar  2 14:55:40 1985
Date-Received: Sun, 3-Mar-85 04:43:46 EST
Distribution: net
Organization: Ohio State Univ., CIS Dept., Cols, Oh.
Lines: 16

I'm having a little trouble getting our Microsoft Fortran Compiler
to work with our AT. The program compiles and links ok, but then when
I try to run it it causes the system to hang. We have the co-processor
chip, and I linked it with that library. I tried following the procedure
for not using the co-processor routines, and that doesn't work
either. In fact, even the demo program included with the compiler had the
same problem. The programs work fine on a regular PC, but not with the
AT. Does anyone have any ideas? Am I doing something wrong, or is our
version of the compiler old, or does this product not work with the
AT's? I'm not that familiar with using the compiler, so it may be something
I'm doing wrong.
-- 
       
       Arun Welch
       Ohio State University
       ...!cbosgd!osu-eddie!welch

Message-ID: <109@whuts.UUCP>
Date: Tue, 5-Mar-85 16:14:52 EST
Article-I.D.: whuts.109
Posted: Tue Mar  5 16:14:52 1985
Date-Received: Thu, 7-Mar-85 04:43:58 EST
References: <143@osu-eddie.UUCP>
Distribution: net
Organization: AT&T Bell Laboratories
Lines: 23

 >  I'm having a little trouble getting our Microsoft Fortran Compiler
 >  to work with our AT. The program compiles and links ok, but then when
 >  I try to run it it causes the system to hang. We have the co-processor
 >  chip, and I linked it with that library. I tried following the procedure
 >  for not using the co-processor routines, and that doesn't work
 >  either. In fact, even the demo program included with the compiler had the
 >  same problem. The programs work fine on a regular PC, but not with the
 >  AT. Does anyone have any ideas? Am I doing something wrong, or is our
 >  version of the compiler old, or does this product not work with the
 >  AT's? I'm not that familiar with using the compiler, so it may be something
 >  I'm doing wrong.
 >  -- 
 >         
 >         Arun Welch
 >         Ohio State University
 >         ...!cbosgd!osu-eddie!welch

urrently running MS Fortran 3.3 under DOS 3.0 on an AT with a 80287 coprocessor.Have not encountered any problems, except when running without coprocessor, 
set no87= is required to get nonzero answers.  I suspect that you have an older relase fo the compiler, which Microsoft's personnel were confused about
AT compatability.

Max Robin
!whuxg!2212msr