G5 Beeps, no startup... [message #330231] |
Fri, 29 July 2016 11:27 |
Zeb Favoovis
Messages: 1 Registered: July 2016
Karma: 0
|
Junior Member |
|
|
Replaced memory in my G5, now it beeps twice and refuses to start. Fans go
to max. RPM. Does anyone know what is wrong?
--
--
You received this message because you are a member of G-Group, a group for those using G3, G4, and G5 desktop Macs - with a particular focus on Power Macs.
The list FAQ is at http://lowendmac.com/lists/g-list.shtml and our netiquette guide is at http://www.lowendmac.com/lists/netiquette.shtml
To post to this group, send email to g3-5-list@googlegroups.com
For more options, visit this group at http://groups.google.com/group/g3-5-list
---
You received this message because you are subscribed to the Google Groups "G-Group" group.
To unsubscribe from this group and stop receiving emails from it, send an email to g3-5-list+unsubscribe@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.
|
|
|
Re: G5 Beeps, no startup... [message #330236 is a reply to message #330231] |
Sun, 31 July 2016 09:19 |
Mac User #330250
Messages: 83 Registered: August 2012
Karma: 0
|
Member |
|
|
On 2016-07-29, 17:27, Zeb Favoovis wrote:
> Replaced memory in my G5, now it beeps twice and refuses to start. Fans go to
> max. RPM. Does anyone know what is wrong?
Hi!
The two beeps mean "Incompatible RAM type installed". Either one DIMM
died or you just recently pulled the DIMMs and reseated them in the
wrong order. http://www.welovemacs.com/whdoallthbme.html
You should try to use only one pair (use the correct slot order). If
this does not work, maybe you included the faulty ones so use a
different pair of DIMMs and try again. See
https://discussions.apple.com/thread/3029247?tstart=0 and
https://support.apple.com/en-us/HT201689 for some information about the
slot order.
Good luck!
--
--
You received this message because you are a member of G-Group, a group for those using G3, G4, and G5 desktop Macs - with a particular focus on Power Macs.
The list FAQ is at http://lowendmac.com/lists/g-list.shtml and our netiquette guide is at http://www.lowendmac.com/lists/netiquette.shtml
To post to this group, send email to g3-5-list@googlegroups.com
For more options, visit this group at http://groups.google.com/group/g3-5-list
---
You received this message because you are subscribed to the Google Groups "G-Group" group.
To unsubscribe from this group and stop receiving emails from it, send an email to g3-5-list+unsubscribe@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.
|
|
|
Re: G5 Beeps, no startup... [message #330238 is a reply to message #330231] |
Sun, 31 July 2016 12:29 |
Kris Tilford
Messages: 133 Registered: August 2012
Karma: 0
|
Senior Member |
|
|
On Jul 29, 2016, at 10:27 AM, Zeb Favoovis <joshsambrook@gmail.com> wrote:
>
> Replaced memory in my G5, now it beeps twice and refuses to start. Fans go to max. RPM. Does anyone know what is wrong?
This is what happens when the power supply is bad. Get a multimeter and check the voltages. Search “PowerMac G5 pinout diagram” for the correct voltages. If you need a power supply, some people have modified standard PC ATX power supplies to work in G5’s. If you’re doing this much work, replace the thermal paste on the CPUs, it’s gotta be completely dried & dead in over a decade.
--
--
You received this message because you are a member of G-Group, a group for those using G3, G4, and G5 desktop Macs - with a particular focus on Power Macs.
The list FAQ is at http://lowendmac.com/lists/g-list.shtml and our netiquette guide is at http://www.lowendmac.com/lists/netiquette.shtml
To post to this group, send email to g3-5-list@googlegroups.com
For more options, visit this group at http://groups.google.com/group/g3-5-list
---
You received this message because you are subscribed to the Google Groups "G-Group" group.
To unsubscribe from this group and stop receiving emails from it, send an email to g3-5-list+unsubscribe@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.
|
|
|
Re: G5 Beeps, no startup... [message #330240 is a reply to message #330238] |
Sun, 31 July 2016 13:55 |
Mac User #330250
Messages: 83 Registered: August 2012
Karma: 0
|
Member |
|
|
On 2016-07-31 18:29 Kris Tilford wrote:
> On Jul 29, 2016, at 10:27 AM, Zeb Favoovis <joshsambrook@gmail.com
> <mailto:joshsambrook@gmail.com>> wrote:
>>
>> Replaced memory in my G5, now it beeps twice and refuses to start. Fans go to
>> max. RPM. Does anyone know what is wrong?
>
> This is what happens when the power supply is bad. Get a multimeter and check
> the voltages. Search “PowerMac G5 pinout diagram” for the correct voltages. If
> you need a power supply, some people have modified standard PC ATX power
> supplies to work in G5’s. If you’re doing this much work, replace the thermal
> paste on the CPUs, it’s gotta be completely dried & dead in over a decade.
Hi!
I disagree because the two beeps indicate a RAM problem.
The fans will always go up if no thermal management is initiated. This
also happens if you stay in the boot selection (holding Alt or Option on
start-up) for a very long time, and also if the PRAM battery is bad and
the start-up sequence doesn't pass the Power-On-Self-Test (POST). (To
name just two cases with high rpm fans.)
Though it *could* also indicate a PSU problem, it seems more likely to
be the replaced memory in this specific case.
Cheers,
Mac User #330250
--
--
You received this message because you are a member of G-Group, a group for those using G3, G4, and G5 desktop Macs - with a particular focus on Power Macs.
The list FAQ is at http://lowendmac.com/lists/g-list.shtml and our netiquette guide is at http://www.lowendmac.com/lists/netiquette.shtml
To post to this group, send email to g3-5-list@googlegroups.com
For more options, visit this group at http://groups.google.com/group/g3-5-list
---
You received this message because you are subscribed to the Google Groups "G-Group" group.
To unsubscribe from this group and stop receiving emails from it, send an email to g3-5-list+unsubscribe@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.
|
|
|
Re: G5 Beeps, no startup... [message #330242 is a reply to message #330238] |
Sun, 31 July 2016 14:31 |
Thomas Fritsch
Messages: 16 Registered: September 2012
Karma: 0
|
Junior Member |
|
|
i Hate to Hijack where are the CPUS located on a Dual G5 Model? (it sparked
me to re-paste my G5 w/ Artic Silver)
as for the OP, it could be a Dying PSU or bad Ram, try to locate an older
PC that used DDR2 Ram, and Run Memtest86+
On Sun, Jul 31, 2016 at 12:29 PM, Kris Tilford <ktilford1@cox.net> wrote:
> On Jul 29, 2016, at 10:27 AM, Zeb Favoovis <joshsambrook@gmail.com> wrote:
>
>
> Replaced memory in my G5, now it beeps twice and refuses to start. Fans go
> to max. RPM. Does anyone know what is wrong?
>
>
> This is what happens when the power supply is bad. Get a multimeter and
> check the voltages. Search “PowerMac G5 pinout diagram” for the correct
> voltages. If you need a power supply, some people have modified standard PC
> ATX power supplies to work in G5’s. If you’re doing this much work, replace
> the thermal paste on the CPUs, it’s gotta be completely dried & dead in
> over a decade.
>
> --
> --
> You received this message because you are a member of G-Group, a group for
> those using G3, G4, and G5 desktop Macs - with a particular focus on Power
> Macs.
> The list FAQ is at http://lowendmac.com/lists/g-list.shtml and our
> netiquette guide is at http://www.lowendmac.com/lists/netiquette.shtml
> To post to this group, send email to g3-5-list@googlegroups.com
> For more options, visit this group at
> http://groups.google.com/group/g3-5-list
>
> ---
> You received this message because you are subscribed to the Google Groups
> "G-Group" group.
> To unsubscribe from this group and stop receiving emails from it, send an
> email to g3-5-list+unsubscribe@googlegroups.com.
> For more options, visit https://groups.google.com/d/optout.
>
--
--
You received this message because you are a member of G-Group, a group for those using G3, G4, and G5 desktop Macs - with a particular focus on Power Macs.
The list FAQ is at http://lowendmac.com/lists/g-list.shtml and our netiquette guide is at http://www.lowendmac.com/lists/netiquette.shtml
To post to this group, send email to g3-5-list@googlegroups.com
For more options, visit this group at http://groups.google.com/group/g3-5-list
---
You received this message because you are subscribed to the Google Groups "G-Group" group.
To unsubscribe from this group and stop receiving emails from it, send an email to g3-5-list+unsubscribe@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.
|
|
|
Re: G5 Beeps, no startup... [message #330244 is a reply to message #330231] |
Mon, 01 August 2016 10:40 |
coverturtle
Messages: 26 Registered: February 2013
Karma: 0
|
Junior Member |
|
|
if everything worked before you made a change, then there is usually
something wrong with that change. First, unplug the power cable and let
the computer "discharge" for at least 30 seconds. Then pull the memory
that you just installed. Check the memory sticks to make sure that they
are the correct type and speed for your computer. Then reinstall the
memory sticks carefully, making sure that the sticks are not reversed
(end-to-end) and that they are fully seated with the locks in place at
each end. If the stick rocked back and forth like a teeter-totter while
you installed it, then remove, recheck that it is not in backwards and
retry. This is most likely what what caused the beeps.
If you did not succeed in booting, check to make sure you have a
keyboard, mouse and monitor/display properly plugged in. Be calm.
Problems are usually easy to diagnose.
Finally, if the memory is significantly different from the original, you
may need to reset the parameter RAM. You can look up how to do that for
your particular model at everymac.com or lowendmac.com.
Just FIY, computer boards are usually very sturdy with at least 6 plies
of epoxy and fiber filler for memory sticks and even more for main
boards and logic boards. They are designed to take the stress of many
slot insertions and card or stick removals.
On 07/29/2016 11:27 AM, Zeb Favoovis wrote:
> Replaced memory in my G5, now it beeps twice and refuses to start.
> Fans go to max. RPM. Does anyone know what is wrong?
> --
> --
> You received this message because you are a member of G-Group, a group
> for those using G3, G4, and G5 desktop Macs - with a particular focus
> on Power Macs.
> The list FAQ is at http://lowendmac.com/lists/g-list.shtml and our
> netiquette guide is at http://www.lowendmac.com/lists/netiquette.shtml
> To post to this group, send email to g3-5-list@googlegroups.com
> For more options, visit this group at
> http://groups.google.com/group/g3-5-list
>
> ---
> You received this message because you are subscribed to the Google
> Groups "G-Group" group.
> To unsubscribe from this group and stop receiving emails from it, send
> an email to g3-5-list+unsubscribe@googlegroups.com
> <mailto:g3-5-list+unsubscribe@googlegroups.com>.
> For more options, visit https://groups.google.com/d/optout.
--
--
You received this message because you are a member of G-Group, a group for those using G3, G4, and G5 desktop Macs - with a particular focus on Power Macs.
The list FAQ is at http://lowendmac.com/lists/g-list.shtml and our netiquette guide is at http://www.lowendmac.com/lists/netiquette.shtml
To post to this group, send email to g3-5-list@googlegroups.com
For more options, visit this group at http://groups.google.com/group/g3-5-list
---
You received this message because you are subscribed to the Google Groups "G-Group" group.
To unsubscribe from this group and stop receiving emails from it, send an email to g3-5-list+unsubscribe@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.
|
|
|